The Scepter designed with a 25 deg skid . Designed to just kill lines .We all so pushed the skid forward for better weight distribution to help with break over we also put a 25deg skid for maximum link clearance.
You will receive
2- Carbon fiber chassis rails
R/L sliders
1x single unicorn mount
1X double unicorn mount
1x skid plate
2x 70mm standoffs
You will have to buy links or make your own.
Options so far are 2low , three gear axial /element stelth x or d1rc low gravity transmission. This is set up to run 4 link soa and outrunner motor Some motors will be a tight fit requiring to flip the top link bolt and put nut on out side of frame.!! Link sizes are
62.5 upper front
67.5lower front
170up rear
183 low rear your going to have to bend for high clearance. That is end to end not eye to eye. Dlux fab has pre cuts in stock
https://dluxfab.com/Links-Rod-Ends-c6232187
.
This is based off of capra axles at 12.75- 13 wheelbase
