The Orb  is Designed with a flat skid to meet c1 rules  .We all so pushed the skid forward for better weight distribution.  

You will receive

2- Carbon fiber chassis rails

R/L sliders

1x skid plate

2x 70mm standoffs

1x panhard cms mount

You will have to buy links or make your own.This is set up to run pan hard bar with cms  you can also run it  4link if your local group does not go by sorcca rules. Designed around out runner style motors. Some motors will be a tight fit requiring to flip the top link bolt and put nut on out side of frame.!! I am running ar45p axles. 12.3 wheel base ..

Links are  80mm pan hard bar

Front up 62.5

Front low 67.5

Rear up 142.5

Rear lower 155

Bend Rear lower links towards axle for high clearance  I use Dlux fab  for TI links. They will have what you need

These are end of link to end of link

****NOT eye to eye****